KTM Suspension tuning is one of the essential tasks that one ought to perform on his/her Dirt Bike. This ensures that your Dirt Bike runs in the efficient way possible. This is because of the steep terrain that these bikes usually go through. When you are setting up the suspension, this needs to be done on both the rear and front ends of your motorbike. We are going to provide a full guide on how to perform a complete dirt bike suspension setup. Here is the guide;
- You need to check the smooth action on the shocks by inspecting the Heim joints and linkage bearings for excess stiction and binding.
- You will then place your bike on the stand. This allows all the suspensions to fully extend thus giving you with the opportunity to take the measurement L1 that is from the Axle center vertically to the point on the chassis.
- You will then remove the bike from the stand, bounce it up and down, and take the measurements L2. This is just the same measurements from the axial center to the chassis.
- After obtaining the readings, you will then subtract L2 from L1 to obtain the Race sag/ Rider.
- You will then adjust your suspensions basing on the Race Sag that you had obtained.
We do not only offer Dirt Bike suspension tuning, but in addition to this, we also offer power parts required in the tuning. We have the Ohlin shocks and the Ohlins suspension, which are essential for Suspension tuning. We also have the anti vibration bar ends that are necessary when it comes improving the performance of the Dirt Bikes. Shop more products like dirt bike clutch kits, radiator guards for dirt bikes, motool slacker and many more from our online store. Visit now http://store.motolabdirtbikes.com/
motolabdirtbikes 